Customize Parameters

HINT: 

The items in the table below can be customized.

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Customize Setting / Smart key/Access or Warning.
5. Select the setting by referring to the table below.
   SMART KEY/ACCESS
   
   

   Tester Display	Default	Content	Setting
   Ignition Available Area (Entry ignition available area)	All	Function to choose the available area for electrical key to start the engine and cancel the steering lock.	Front or All*

   *: Weak radio waves will still be emitted from oscillators other than the front oscillator even when the "Front" customize setting is selected.

   WARNING
   
   

   Tester Display	Default	Content	Setting
   Key Low Battery Warning	ON	Function that warns driver that key battery is weak	ON or OFF

Performing the following procedure disables the smart access system with push-button start.

HINT: 

To start the engine while the smart access system with push-button start is disabled, follow the procedure for when the key battery is low. Refer to SYSTEM DESCRIPTION .

1. The operation procedures are as follows:

   Precondition:

   Engine switch off, driver side door closed and unlocked.

   1. Push the unlock switch of the key once.
   2. Open the driver door within 5 seconds.
   3. Push the unlock switch of the key twice within 5 seconds.
   4. Close and open the driver door twice within 30 seconds.

      (Driver door: Close → Open → Close → Open)

   5. Push the unlock switch of the key twice within 5 seconds.
   6. Close and open the driver door within 30 seconds.

      (Driver door: Close → Open)

   7. Close the driver door within 5 seconds.

      When electrical key cancel is activated, the wireless door lock buzzer sounds twice.

      To return to the original condition, perform the procedures again. When the original condition is returned, the wireless door lock buzzer sounds once.