Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Lexus LS 600hLFACTORY OEM SERVICE PROCEDURE
Power Switch: Installation: Installation
- INSTALL POWER SWITCH
- Attach the 2 claws to install the switch.
- Connect the switch connector.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY . Refer to INSTALLATION - Step 27
- INSTALL NO. 1 INSTRUMENT CLUSTER MOLDING . Refer to INSTALLATION - Step 28
- INSTALL INSTRUMENT SIDE PANEL LH . Refer to INSTALLATION - Step 29
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
- INSTALL BATTERY SERVICE HOLE COVER LH . Refer to INSTALLATION - Step 15
- INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY . Refer to INSTALLATION - Step 17
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.