Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Oil Replacement Reminder Reset - Procedure 08
To reset MAINT REQD reminder light after engine oil change:
- With ignition switch on, push ODO/TRIP button to change display to blank.
- Turn ignition switch to OFF position.
- Turn ignition switch to ON position, while holding trip meter RESET button down.
- Continue pushing RESET button for more than 5 seconds, after the ignition switch is turned to ON position.
- Master warning light comes on, a warning tone sounds, and MILEAGE RESET message appears, to inform that engine oil maintenance data has been reset.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.