2012 Lexus LS 460L AWDFACTORY OEM SERVICE PROCEDURE

Intake Manifold: Installation: Installation

  1. INSTALL INTAKE MANIFOLD 
    1. Install 2 new gaskets to the intake manifold.
    2. Temporarily install the intake manifold with the 2 nuts and 8 bolts. Then tighten the 2 nuts and 8 bolts uniformly in the order shown.

      Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) 

      Fig 1: Identifying Intake Manifold Bolts Tightening Sequence
      GTY105294Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the PCV hose to the intake manifold.
      Fig 2: Identifying PCV Hose And Clip
      GTY105295Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.