Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Oil Replacement Reminder Reset - Procedure 06
To reset MAINT REQD reminder light after engine oil change:
- Turn ignition switch to OFF position with odometer display showing.
- Turn ignition switch to ON position while holding down ODO/TRIP knob.
- Hold ODO/TRIP reset knob down until reminder light goes OFF.NOTE: Before reminder light goes OFF, it will illuminate for 3 seconds, flash for 2 seconds and illuminate for one second.
- If system fails to reset, reminder light will remain flashing.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.