Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch: Procedure
- READ VALUE USING TECHSTREAM (Master Switch)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Master switch / Data List.
- Read the Data List according to the display on the Techstream.MASTER SWITCH (MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY)
Tester Display Measurement Item/Range Normal Condition Diagnostic Note D Door P/W Auto SW Driver side power window auto up/down switch signal / ON or OFF ON: Driver side power window auto switch operated
OFF: Driver side power window auto switch not operated- OK
On the Techstream screen, ON or OFF is displayed accordingly.
NG → See step 4
OK: Go to next step
- REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side)
- Replace the power window regulator motor assembly (for driver side). Refer to REMOVAL .
NEXT: Go to next step
- CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)
- Check that the driver side door power window moves when the auto up/down function of the multiplex network master switch assembly is operated. Refer to OPERATION CHECK .
OK
Driver side auto up/down function is normal.
NG → See step 4
OK → END (POWER WINDOW REGULATOR MOTOR ASSEMBLY IS DEFECTIVE)
- Check that the driver side door power window moves when the auto up/down function of the multiplex network master switch assembly is operated. Refer to OPERATION CHECK .
- REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY. Refer to REMOVAL
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
