2012 Lexus IS 250C Automatic TransFACTORY OEM SERVICE PROCEDURE

Monitor Strategy

Related DTCs P0125: Insufficient engine coolant temperature for closed loop fuel control
Required Sensors/Components (Main) Engine coolant temperature sensor, thermostat, cooling system
Required Sensors/Components (Related) -
Frequency of Operation Once per driving cycle
Duration 84 seconds: Engine coolant temperature at engine start is (closed-loop engine coolant temperature - 8.33°C [46.994°F]) or more
164 seconds: Engine coolant temperature at engine start is (closed-loop engine coolant temperature - 19.44°C [66.922°F]) or more, and less than (closed-loop engine coolant temperature - 8.33°C [46.994°F])
1200 seconds: Engine coolant temperature at engine start is less than (closed-loop engine coolant temperature - 19.44°C [66.922°F])
MIL Operation 2 driving cycles
Sequence of Operation None
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.