2012 Lexus IS 250C Automatic TransFACTORY OEM SERVICE PROCEDURE

Jam Protection Function does not Operate: Procedure

  1. PERFORM INITIALIZATION (POWER WINDOW CONTROL SYSTEM (APPLICABLE LOCATION)) 
    1. Initialize the power window control system (applicable location). Refer to INITIALIZATION .

    NEXT: Go to next step 

  2. CHECK JAM PROTECTION FUNCTION OPERATING RANGE 
    1. Check if the jam protection function operates normally for the applicable power window.

      HINT: 

      The jam protection function will not operate within 15 mm (0.591 in.) of the fully closed position.

      OK

      Jam protection function operates normally.

      RESULT

      Result Proceed to
      OK A
      NG (Driver door window) B
      NG (Front passenger door window) C

    B → See step   3 

    C → See step   4 

    A → END (INITIALIZATION WAS INCORRECT) 

  3. REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY. Refer to  REMOVAL 
  4. REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY. Refer to  REMOVAL 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.