2012 Lexus IS 250 Base, AWDFACTORY OEM SERVICE PROCEDURE

Rear Speed Sensor: Removal: Removal

HINT: 

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.
  1. REMOVE REAR WHEEL 
  2. REMOVE REAR SPEED SENSOR 
    1. Disconnect the rear speed sensor connector.
      Fig 1: Identifying Speed Sensor, Connector, & Bolt
      GTY108627Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and rear speed sensor.
      NOTE:

      Prevent foreign matter from attaching to the sensor tip.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.