2012 Lexus HS 250hFACTORY OEM SERVICE PROCEDURE

Air Fuel Ratio Sensor: Removal: Removal

  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY  . Refer to REMOVAL - Step 28
  2. REMOVE AIR FUEL RATIO SENSOR 
    1. Disconnect the air fuel ratio sensor connector.
      Fig 1: Identifying Air Fuel Ratio Sensor Connector
      GTY267458Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using SST, remove the air fuel ratio sensor.
      Fig 2: Identifying SST & Air Fuel Ratio Sensor
      GTY259590Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09224-00010 
      NOTE: Do not damage the air fuel ratio sensor.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.