Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Lexus HS 250hFACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Table
HINT:Β
If a trouble code is stored during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the reference below.
POWER MANAGEMENT CONTROL ECU
| DTC Code | Detection Item | Trouble Area | Reference |
|---|---|---|---|
| B2271 | Ignition Hold Monitor Malfunction | AM2 fuse IG1 relays NO. 1 integration relay (IG2 relay) Power management control ECU Instrument panel junction block assembly Wire harness or connector |
Refer to DTC B2271: Ignition Hold Monitor Malfunction |
| B2274 | ACC Monitor Malfunction | AM2 fuse Power management control ECU Instrument panel junction block assembly (ACC relay, P/POINT relay) Wire harness or connector |
Refer to DTC B2274: ACC Monitor Malfunction |
| B2275 | STSW Monitor Malfunction | AM2 fuse Hybrid vehicle control ECU Power management Control ECU Wire harness or connector |
Refer to DTC B2275: STSW Monitor Malfunction |
| B2277 | Detecting Vehicle Submersion | Power management control ECU | Refer to DTC B2277: Detecting Vehicle Submersion |
| B2282 | Vehicle Speed Signal Malfunction | CAN communication system Combination meter assembly Power management control ECU Junction connector Wire harness or connector |
Refer to DTC B2282: Vehicle Speed Signal Malfunction |
| B2284 | Brake Signal Malfunction | AM2 fuse STOP fuse Stop light switch assembly CAN communication system Skid control ECU assembly Power management control ECU Wire harness or connector |
Refer to DTC B2284: Brake Signal Malfunction |
| B2286 | Runnable Signal Malfunction | AM2 fuse Hybrid vehicle control ECU Power management control ECU Wire harness or connector |
Refer to DTC B2286: Runnable Signal Malfunction |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
