Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Lexus GX 460FACTORY OEM SERVICE PROCEDURE
Downhill Assist Control Switch: Inspection: Inspection
- CHECK COMBINATION SWITCH ASSEMBLY (DOWNHILL ASSIST CONTROL SWITCH)Β
- Measure the resistance according to the value(s) in the table below.
Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Standard Resistance
Tester Connection Switch Condition Specified Condition 9 (E) - 15 (+B2) Pressed Below 1 Ξ© Not pressed 10 kΞ© or higher TEXT IN ILLUSTRATION*a Component without harness connected
(Combination Switch)If the result is not as specified, replace the combination switch assembly (downhill assist control switch).
- Measure the resistance according to the value(s) in the table below.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
