2011 Lexus RX 350 AWDFACTORY OEM SERVICE PROCEDURE

Mass Air Flow Meter: Removal: Removal

  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY 
    1. Remove the windshield wiper motor and link assembly. Refer to REMOVAL .
  2. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY  . Refer to REMOVAL - Step 8
  3. REMOVE MASS AIR FLOW METER 
    1. Separate the mass air flow meter connector.
      Fig 1: Identifying Mass Air Flow Meter Connector
      GTY271281Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 screws and mass air flow meter.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.