REMOVE ENGINE ROOM SIDE COVER LH . Refer to REMOVAL - Step 1
REMOVE ENGINE ROOM SIDE COVER RH . Refer to REMOVAL - Step 2
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
- After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
DISCONNECT CONNECTOR HOLDER BLOCK
1. Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.
  
  Fig 1: Locating Connector Holder Block Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE ECM
1. Raise the 2 levers while pushing the locks on the 2 levers.
  NOTE:
  Make sure that the lock levers are raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may cause the connectors to break.

Chapter Navigation

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Removal (08/2010 - 08/2011): Removal