Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
On-Vehicle Inspection
- CHECK SHIFT LOCK OPERATION
- Move the shift lever to the P position.
- Turn the power switch off.
- Check that the shift lever cannot be moved to any position other than P.
- Turn the power switch on (IG), depress the brake pedal and check that the shift lever can be moved to other positions.
- CHECK SHIFT LOCK RELEASE BUTTON OPERATION
- When operating the shift lever with the shift lock release button pressed, check that the lever can be moved to any position other than P.
If the operation cannot be performed as specified, check the shift lever assembly.
- When operating the shift lever with the shift lock release button pressed, check that the lever can be moved to any position other than P.
- CHECK SHIFT LOCK CONTROL ECU
- Measure the voltage according to the values in the table below.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
HINT:
Do not disconnect the shift lock control ECU connector.
Standard voltage
Tester Connection Condition Specified Condition 12 (IG) - 3 (E) Power switch on (IG) 10 to 14 V 12 (IG) - 3 (E) Power switch off Below 1 V 6 (STP) - 3 (E) Brake pedal depressed 10 to 14 V 6 (STP) - 3 (E) Brake pedal released Below 1 V 11 (P2) - 3 (E) Shift lever in any position except P 10 to 14 V 11 (P2) - 3 (E) Shift lever in P position Below 1.5 V - Measure the resistance according to the value in the table below.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
HINT:
Do not disconnect the shift lock control ECU connector.
Standard resistance
Tester Condition Condition Specified Condition 3 (E) - Body ground Always Below 1 Ω If the result is not as specified, replace the transmission floor shift assembly.
- Measure the voltage according to the values in the table below.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
