Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Lexus LS 600hLFACTORY OEM SERVICE PROCEDURE
DTC P060E: Internal Control Module Throttle Position Performance: Procedure
- CHECK DTC
- Clear DTC. Refer to DTC CHECK / CLEAR .
- Turn the power switch off.
- Disconnect the cable from the negative battery terminal and wait for 1 minute.
- Connect the cable to the negative battery terminal.
- Turn the power switch on (IG).
- Check DTC.
OK
P060E is not present.
NG → See step 3
OK → See step 2
- CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS
- REPLACE ECM. Refer to REMOVAL
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.