Heated Oxygen Sensor: Removal: Removal

HINT: 

When viewed from the rear of the engine assembly, Bank 1 is on the left side and Bank 2 is on the right side.

1. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) 
   1. Disconnect the sensor connector.
      Fig 1: Locating Sensor Connector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Using SST, remove the sensor from the front exhaust pipe.
      • SST: 09224-00010 
2. REMOVE FRONT DOOR SCUFF PLATE RH 
   1. Remove the front door scuff plate RH. Refer to REMOVAL - Step 11 .
3. REMOVE COWL SIDE TRIM BOARD RH 
   1. Remove the cowl side trim board RH. Refer to REMOVAL - Step 13 .
4. REMOVE FRONT FLOOR SILENCER PAD RH 
5. REMOVE REAR NO. 2 AIR DUCT 
6. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) 
   1. Interior Side:

      Disconnect the sensor connector.

      Fig 2: Locating Heated Oxygen Sensor Connector

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Exterior Side:
      1. Remove the grommet.
         Fig 3: Locating Sensor Connector (Exterior Side)

         Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Using SST, remove the sensor from the front exhaust pipe.
         • SST: 09224-00010