2011 Lexus LS 460L RWDFACTORY OEM SERVICE PROCEDURE

Camshaft Timing Control Motor: Removal: Removal

  1. REMOVE V-BANK COVER SUB-ASSEMBLY  . See step  3
  2. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY  . See step  4
  3. REMOVE NO. 1 AIR CLEANER INLET  . See step  5
  4. REMOVE INTAKE AIR CONNECTOR PIPE  . See step  8
  5. REMOVE CAMSHAFT TIMING CONTROL WITH EDU MOTOR ASSEMBLY RH 
    1. Disconnect the 2 camshaft timing control with EDU motor connectors.
      Fig 1: Identifying Camshaft Timing Control With EDU Motor Connectors And Harness Bracket Bolt
      GTY276321Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and engine wire bracket.
    3. Remove the 3 bolts and camshaft timing control with EDU motor.
      Fig 2: Identifying Camshaft Timing Control With EDU Motor
      GTY277650Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Chapter Navigation
Return to Chapter: Removal
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.