2011 Lexus LS 460L AWDFACTORY OEM SERVICE PROCEDURE

Customize Parameters

  1. CUSTOMIZING FUNCTION WITH TECHSTREAM 

    HINT: 

    The following items can be customized.

    NOTE:
    • When the customer requests a change in a function, first make sure that customize of the function is possible.
    • Be sure to make a note of the current settings before customizing.
    • When troubleshooting a function, first make sure that the function is set to the default setting.
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Customize Setting.
    5. Select the setting by referring to the table below.
      DOOR LOCK

      Display (Item) Default Contents Setting
      Auto Unlock/Shift
      (Unlock w/ engine switch on (IG), shift P, speed 0 km/h (0 mph))      		 ON Function that unlocks all doors when lever is shifted to P from any position other than P while the engine switch is on (IG) ON/OFF
      All Unlock/Open-Close
      (All unlock w/ D door open-close)      		 OFF Function that unlocks all other doors when opening driver door within 10 seconds after turning the engine switch is on (IG) ON/OFF
      Unlock Key Twice
      (Unlock w/ 2 times D key operation)      		 ON Function that unlocks only driver side door when driver side door key cylinder is turned to unlock once, and unlock all doors when it is turned to unlock twice. For OFF setting, turning it once unlocks all doors. ON/OFF
      Auto Lock/Shift
      (Auto lock/shift not P)      		 ON*1
      OFF*2      		 With engine running and all doors closed, function that locks all doors when lever is shifted to P from any position other than P ON/OFF
      Auto Lock OFF*1
      ON*2      		 Function that locks all doors when vehicle speed reaches a certain level ON/OFF

      HINT: 

      *1: Except Korea

      *2: for Korea

Chapter Navigation
Return to Chapter: Customize Parameters
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.