Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
How To Proceed With Troubleshooting
HINT:Â
*: Use Techstream.
- VEHICLE BROUGHT TO WORKSHOPÂ
NEXT: Go to next stepÂ
- CUSTOMER PROBLEM ANALYSISÂ
NEXT: Go to next stepÂ
- PASSENGER AIRBAG ON/OFF INDICATOR CHECKÂ
NEXT: Go to next stepÂ
- DTCs CHECK (Present and Past DTCs)*Â
- Check for DTCs.
Result
Result Proceed to DTC is output. A DTC is not output. B B → GO TO PROBLEM SYMPTOMS TABLE  OCCUPANT CLASSIFICATION SYSTEM (TO 12/2010)  OCCUPANT CLASSIFICATION SYSTEM (FROM 12/2010) Â
A: Go to next stepÂ
- Check for DTCs.
- DTCs CHARTÂ
NEXT: Go to next stepÂ
- CIRCUIT INSPECTION*Â
NEXT: Go to next stepÂ
- REPAIRÂ
NEXT: Go to next stepÂ
- CLEAR DTCs (Present and Past DTCs)*Â
- Clear for DTCs.
NEXT: Go to next stepÂ
- Clear for DTCs.
- DTCs CHECK (Present and Past DTCs)*Â
- Check for DTCs.
Result
Result Proceed to DTC is not output. A DTC is output. B B → Go to   5 step 5Â
A: Go to next stepÂ
- Check for DTCs.
- SYMPTOM SIMULATIONÂ
- Check the passenger airbag ON/OFF indicator condition.
Result
Result Proceed to Passenger airbag ON/OFF indicator is operate normally. A Passenger airbag ON/OFF indicator ("OFF") and SRS warning light comes on. B B → Go to   5 step 5Â
A: Go to next stepÂ
- Check the passenger airbag ON/OFF indicator condition.
- CONFIRMATION TESTÂ
NEXT → ENDÂ
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
