Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Lexus IS FFACTORY OEM SERVICE PROCEDURE
Pattern Select Switch: Removal: Removal
- REMOVE FRONT DOOR SCUFF PLATE LH . Refer to REMOVAL - Step 40
- REMOVE FRONT DOOR OPENING TRIM COVER LH . Refer to REMOVAL - Step 42
- REMOVE SIDE INSTRUMENT PANEL LH . Refer to REMOVAL - Step 26
- REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY . Refer to REMOVAL - Step 28
- REMOVE NO. 1 PATTERN SELECT SWITCH ASSEMBLY
- Disengage the 4 claws to remove the switch base from the lower instrument panel finish panel.
- Disengage the 2 claws to remove the pattern select switch from the switch base.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.