2011 Lexus IS FFACTORY OEM SERVICE PROCEDURE

DTC P0116: Engine Coolant Temperature Circuit Range / Performance Problem: Procedure

  1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine / Trouble Codes.
    5. Read the DTC.

      Result

      Result Proceed to
      DTC P0116 is output A
      DTC P0116 and other DTCs are output B

      HINT: 

      If any DTCs other than P0116 are output, troubleshoot those DTCs first.

    B → See step   4 

    A: Go to next step 

  2. INSPECT WATER INLET WITH THERMOSTAT 
    1. Remove the water inlet with thermostat. Refer to REMOVAL .
    2. Check the valve opening temperature of the thermostat.

      Standard

      80°C to 84°C (176°F to 183°F)

      HINT: 

      In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.

    3. Reinstall the water inlet with thermostat. Refer to INSTALLATION .

    NG → See step   5 

    OK → See step   3 

  3. REPLACE ENGINE COOLANT TEMPERATURE SENSOR. Refer to  REMOVAL 
  4. GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART 
  5. REPLACE WATER INLET WITH THERMOSTAT. Refer to  REMOVAL 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.