2011 Lexus IS FFACTORY OEM SERVICE PROCEDURE

System Description

  1. INTEGRATION CONTROL AND PANEL ASSEMBLY*1 OR MULTI-DISPLAY*2 (CLOCK) 
    Fig 1: Integration Control And Panel Assembly*1 Or Multi-Display*2 (Clock)
    GTY355522Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    HINT: 

    • Integration control and panel assembly*1 consists of three parts (passenger information display, clock display and heater control panel). These areas display the contents given in the table below.
    • Multi-display*2 consists of four parts (navigation display, passenger information display, clock display, and heater control panel). These areas display the contents given in the table below.
    Item Detail
    Passenger information display Displays the condition of the front passenger side seat belt OFF or ON.
    Heater control panel Displays the condition of the heater control panel.
    Clock display The time is always displayed. In addition, the display dims according to the signal from the combination meter.
    Navigation display*2 Displays the navigation data.
    • *1: w/o Navigation System
    • *2: w/ Navigation System
Chapter Navigation
Return to Chapter: System Description
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.