2011 Lexus IS 350CFACTORY OEM SERVICE PROCEDURE

System Description

WARNING: This page is about a different car, the 2011 Lexus IS 350 and 2011 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. GENERAL DESCRIPTION 
    1. In the occupant classification system, the occupant classification ECU calculates the weight of the front passenger based on a signal from the occupant detection sensor. This system judges the occupant to be a child when it detects a weight of less than 27.3 kg (60 lb), and disables the front passenger side airbag and front passenger side - side airbag.
    2. This system is mainly composed of the occupant detection sensor that detects the load on the front passenger seat. The occupant classification ECU controls the system, and the passenger airbag ON/OFF indicator indicates the ON/OFF condition of the front passenger airbag and front passenger side - side airbag.
  2. OCCUPANT DETECTION SENSOR 
    1. The occupant detection sensor consists of the gel mat and the pressure sensor.

      When weight is applied to the gel mat, the pressure applied through the silicone to the pressure sensor changes. The pressure sensor converts these changes into voltages and transmits them to the occupant classification ECU.

      Fig 1: Identifying Occupant Classification ECU, Pressure Sensor, Gel Mat, & Occupant Voltage/Pressure Graph
      GTY110594Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. The occupant detection sensor is installed between the seat cushion frame and seat cushion pad. The pressure sensor is installed on the seat frame.
    3. The pressure sensor detects the pressure applied to the front passenger seat as a seated passenger. The occupant classification ECU determines whether the front passenger side airbag and front passenger side - side airbag are deployed based on signals from the pressure sensor.
  3. SEAT BELT TENSION SENSOR 
    1. The seat belt tension sensor is installed on the front seat outer belt to detect a CRS (Child Restraint System).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.