Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2011 Lexus IS 350CFACTORY OEM SERVICE PROCEDURE

VSC Off Switch: Installation: Installation

INSTALL VSC OFF SWITCH
1. Engage the 2 claws and install the VSC OFF switch to the switch base.
  
  Fig 1: Locating Claws Of VSC OFF Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Engage the 4 claws and install the VSC OFF switch with switch base to the lower instrument panel finish panel sub-assembly.
  
  Fig 2: Identifying 4 Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LOWER INSTRUMENT FINISH PANEL SUB-ASSEMBLY . Refer to INSTALLATION - Step 24
INSTALL SIDE INSTRUMENT PANEL LH . Refer to INSTALLATION - Step 26
INSTALL FRONT DOOR OPENING TRIM COVER LH . Refer to INSTALLATION - Step 15
INSTALL DOOR SCUFF PLATE ASSEMBLY LH . Refer to INSTALLATION - Step 16
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Chapter Navigation

Return to Chapter: Installation

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.