2011 Lexus IS 350CFACTORY OEM SERVICE PROCEDURE

Problem Symptoms Table

HINT:Β 

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

CLOCK ASSEMBLY

Symptom Suspected Area See
Clock does not operate at all. Fuse (MPX-B, ACC, ECU-IG RH) -
Power Source Circuit (w/o Navigation System) Refer to TERMINALS OF ECU
Power Source Circuit (w/ Navigation System) Refer to TERMINALS OF ECU
Clock display illumination malfunction Illumination Circuit Refer to TERMINALS OF ECU
Clock loses or gains time. Clock Assembly (w/o Navigation System) Refer to REMOVAL - Step 23
Clock Assembly (w/ Navigation System) Refer to REMOVAL - Step 23
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.