2011 Lexus IS 350 Base, AWDFACTORY OEM SERVICE PROCEDURE

Torque Specifications

Part Tightened N.m kgf cm ft. lbf
Fuel delivery pipe sub-assembly x Intake manifold 17 173 13
Intake air surge tank x Intake manifold
: for nuts
16 163 12
Intake air surge tank x Intake manifold
: for bolts
18 184 13
Surge tank stay x Intake air surge tank 21 214 15
Water hose joint x Intake air surge tank 10 102 7
No. 1 vacuum switching valve assembly x Intake air surge tank 18 184 13
No. 1 fuel delivery pipe x Cylinder head 26 265 19
No. 2 fuel delivery pipe x Cylinder head 26 265 19
No. 3 fuel pipe x No. 1 fuel delivery pipe 10 102 7
No. 3 fuel pipe x No. 2 fuel delivery pipe 10 102 7
No. 1 fuel pipe x Cylinder head cover 10 102 7
Water hose joint x Camshaft housing sub-assembly RH 10 102 7
Intake manifold x Cylinder head 21 214 15
Fuel pressure pulsation damper x Fuel pump (for high pressure)
: for use without SST
40 408 30
Fuel pressure pulsation damper x Fuel pump (for high pressure)
: for use with SST
34 347 25
Fuel pressure sensor x No. 1 fuel delivery pipe
: for use without SST
42 428 31
Fuel pressure sensor x No. 1 fuel delivery pipe
: for use with SST
23 235 17
Fuel relief valve assembly x No. 2 fuel delivery pipe 40 408 29
Injector driver x Engine assembly 10 102 7
Fuel tank vent tube set plate x Fuel tank 6.0 6.0 53 in. lbf
Fuel pump (for high pressure) x Cylinder head cover RH 25 255 18
No. 2 fuel pipe x No. 1 fuel delivery pipe 10 102 7
No. 2 fuel pipe x Fuel pump (for high pressure) 30 306 22
Fuel pump resistor x Body 5.0 51 44 in. lbf
Fuel pump resistor x Ground wire 8.0 80 69 in. lbf
No. 1 fuel tank breather tube sub-assembly x Fuel tank assembly 1.5 15 13 in. lbf
Fuel tank x Body 39 400 29
Rear suspension member brace RH x Body 19 195 14
Rear suspension member brace LH x Body 19 195 14
Parking brake cable assembly x Body
: for bolt A
6.0 6.0 53 in. lbf
Parking brake cable assembly x Rear suspension member sub-assembly
: for bolt B
19 194 14
Fuel sender gauge assembly x Fuel tank assembly 1.5 15 13 in. lbf
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.