2011 Lexus IS 350 Base, AWDFACTORY OEM SERVICE PROCEDURE

Torque Specifications

Part tightened N.m kgf cm ft. lbf
Brake actuator assembly x Brake actuator bracket assembly 5.4 55 48 in. lbf
Brake actuator bracket assembly x Body 19 194 14
Brake actuator assembly x Brake tube 14 (15) 143 (155) 10 (11)
Front speed sensor (for 4WD) 8.5 87 75 in. lbf
Rear speed sensor 8.5 87 75 in. lbf
Yaw rate and acceleration sensor 15 148 11

(): without union nut wrench

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.