Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Steering Lock System: Precaution: Precaution
- PRECAUTIONS WHEN WORKING ON ELECTRIC STEERING LOCK
- After replacing the steering lock actuator assembly (steering lock ECU), perform the key code registration.
- If the steering lock actuator assembly is replaced, open and close the driver's door. The engine may not start until either operation is performed.
HINT:
Opening and closing the driver's door causes the steering lock actuator assembly (steering lock ECU) to memorize the correct steering lock bar position.
- If checking for DTCs of the push-button start function or checking the Data List with the engine switch off, make sure that the driver's door is open.
HINT:
When the engine switch is off, the main body ECU RH (cowl side junction block RH) may be in a sleep mode. If the main body ECU RH (cowl side junction block RH) is in this sleep mode, it will not be possible to communicate with the Techstream.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.