Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Lexus IS 250C AutomaticFACTORY OEM SERVICE PROCEDURE
VSC Off Switch: Installation: Installation
WARNING: This page is about a different car, the 2011 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL VSC OFF SWITCH
- Engage the 2 claws and install the VSC off switch to the switch base.
- Engage the 4 claws and install the VSC off switch the with switch base to the lower instrument panel finish panel sub-assembly.
- INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY . Refer to INSTALLATION - Step 23
- INSTALL SIDE INSTRUMENT PANEL LH . Refer to INSTALLATION - Step 25
- INSTALL FRONT DOOR OPENING TRIM COVER LH . Refer to INSTALLATION - Step 79
- INSTALL FRONT DOOR SCUFF PLATE LH . Refer to INSTALLATION - Step 81
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.