Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Lexus IS 250C AutomaticFACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Chart
WARNING: This page is about a different car, the 2011 Lexus IS 350 and 2011 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
HINT:Β
If a trouble code is indicated during the DTC check, check the circuit listed for that code in the table below. Then proceed to the appropriate information.
POWER DOOR LOCK CONTROL SYSTEM:
| DTC Code | Detection Item | Trouble Area | See |
|---|---|---|---|
| B1242 | Wireless Door Lock Tuner Circuit Malfunction | 1. Door control receiver 2. Wire harness 3. Certification ECU |
Refer to DTC B1242: Wireless Door Lock Tuner Circuit Malfunction |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
