Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Lexus GS 460FACTORY OEM SERVICE PROCEDURE
Adaptive Variable Suspension System
ADAPTIVE VARIABLE SUSPENSION SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC Code | Description |
|---|---|
| C1715 | Front Acceleration Sensor RH |
| C1716 | Front Acceleration Sensor LH |
| C1717 | Rear Acceleration Sensor |
| C1725 | Front Damping Force Control Actuator RH Circuit |
| C1726 | Front Damping Force Control Actuator LH Circuit |
| C1727 | Rear Damping Force Control Actuator RH Circuit |
| C1728 | Rear Damping Force Control Actuator LH Circuit |
| C1761 | Suspension Control ECU Malfunction |
| C1773 | VGRS ECU Malfunction |
| C1774 | Low Battery Positive Voltage |
| C1776 | Speed Sensor Circuit |
| C1777 | Steering Angle Sensor Circuit |
| C1787 | EMS Switch Circuit (Test Mode DTC) |
| C1791 | Front Acceleration Sensor RH (Test Mode DTC) |
| C1792 | Front Acceleration Sensor LH (Test Mode DTC) |
| C1793 | Rear Acceleration Sensor (Test Mode DTC) |
| U0100 | Lost Communication with ECM / PCM "A" |
| U0101 | Lost Communication with TCM |
| U0122 | Lost Communication with Vehicle Dynamics Control Module |
| U0126 | Lost Communication with Steering Angle Sensor Module |
| U0130 | Lost Communication with VGRS |
| U0132 | Lost Communication with Absorber Control ECU |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
