2011 Lexus GS 460FACTORY OEM SERVICE PROCEDURE

Occupant Classification System: Initialization: Initialization

WARNING: This page is about a different car, the 2009 Lexus IS 350 and 2009 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Make sure that the front passenger seat is not occupied before performing the operation.

HINT: 

Perform the zero point calibration if any of the following conditions is met:

  • The occupant classification ECU is replaced.
  • The passenger airbag ON/OFF indicator indicates OFF when the front passenger seat is not occupied.
  • The vehicle is brought to the workshop for repair due to an accident or a collision.
  1. ZERO POINT CALIBRATION 
    1. Zero point calibration procedures
      1. Check that all of the following conditions are met:
        • The vehicle is parked on a level surface.
        • No objects are placed on the front passenger seat.
        • The front passenger seat belt buckle switch is OFF.
      2. Adjust the seat position according to the table below.
        Adjustment Item Position
        Slide Direction Rearmost position
        Reclining Angle Upright position
        Headrest Height Lowest position
        Lifter Height Lowest position
      3. Connect the Techstream to the DLC3.
      4. Turn the engine switch on (IG).
      5. Enter the following menus: Body Electrical / Occupant Detection / Utility / Zero Point Calibration.
      6. Perform the zero point calibration by following the prompts on the Techstream screen.

        HINT: 

        • Refer to the Techstream operator's manual for further details.
        • If the zero point calibration is performed when the calibration conditions are not satisfied, DTC B1797 is output.
        • If the zero point calibration has failed, DTC B1797 is output.
        • If After Exchange is selected before the previous ECU data are stored in the Techstream, the display screen returns to CONDITION SELECT ECU: Occupant Detect.
          Item Procedure
          DTC Perform DTC check and repair
          Write error Replace front seat cushion assembly (with occupant classification ECU and occupant detection sensor)
          Temperature Check value of THERMISTOR TEMP in ECU DATA LIST
          Pressure Check value of FILTERED PRESS in ECU DATA LIST
          Crash counter -
  2. SENSITIVITY CHECK 
    1. Sensitivity check procedures
      1. Turn the engine switch off.
      2. Place a weight of 20 kg (44.0 lb) on the front passenger seat.
        Fig 1: Identifying Weight On Front Passenger Seat
        GTY127573Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.