Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Check/Clear
- CHECK DTC
- Connect the Techstream (with CAN VIM) to the DLC3.
- Turn the power switch ON (IG).
- Read the DTCs by following the directions on the tester's screen.
HINT:
- When using the Techstream with the power switch OFF to troubleshoot:
Connect the Techstream to the vehicle, and turn a courtesy light switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.
- Refer to the Techstream operator's manual for further details.
- When using the Techstream with the power switch OFF to troubleshoot:
- CLEAR DTC
- Connect the Techstream (with CAN VIM) to the DLC3.
- Turn the power switch ON (IG).
- Erase the DTCs by following the directions on the tester's screen.
HINT:
- When using the Techstream with the power switch OFF to troubleshoot:
Connect the Techstream to the vehicle, and turn a courtesy light switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.
- Refer to the Techstream operator's manual for further details.
- When using the Techstream with the power switch OFF to troubleshoot:
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.