Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Lexus ES 350FACTORY OEM SERVICE PROCEDURE
NAVIGATION SYSTEM (for HDD)
NAVIGATION SYSTEM (FOR HDD) DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC Code | Description |
|---|---|
| B156B | Multimedia Interface ECU Disconnected |
| B156E | No Response from Multimedia Interface ECU |
| B1591 | No Response from Audio HU |
| B1593 | No Response from Stereo Component Amplifier |
| B15A0 | LAN Master Malfunction |
| B15AD | Navigation Processor Malfunction |
| B15B0 | Display Screen Malfunction |
| B15B8 | Hard Disk Malfunction |
| B15C0 | Short in GPS Antenna |
| B15C1 | Open in GPS Antenna |
| B15C2 | Speed Signal Malfunction |
| B15D0 | MOST Communication Malfunction |
| B15D1 | Audio HU Disconnected |
| B15D3 | Stereo Component Amplifier Disconnected |
| B15E7 | Hard Disk Reading/Writing Malfunction (Low Temperature) |
| B15E8 | Harddisk Reading/Writing Malfunction (High Temperature) |
| B15F5 | A/C ECU Vehicle Information Reading/Writing Processor Malfunction |
| B15F6 | Main Body ECU Vehicle Information Reading/Writing Process Malfunction |
| B15F7 | Certification ECU Vehicle Information Reading/Writing Process Malfunction |
| U0073 | Control Module Communication Bus Off |
| U0164 | Lost Communication with A/C ECU |
| U1110 | Lost Communication with Clearance Warning ECU |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.