2011 Lexus ES 350FACTORY OEM SERVICE PROCEDURE

DTC P060E: Internal Control Module Throttle Position Performance: Procedure

  1. READ OUTPUT DTC (DTC P060E) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream ON.
    4. Clear the DTC. Refer to DTC CHECK/CLEAR .
    5. Turn the engine switch to off and turn the Techstream off.
    6. Disconnect the Techstream.
    7. Disconnect the cable from the battery negative (-) terminal and wait for 1 minute.
    8. Connect the cable to the battery negative (-) terminal.
    9. Connect the Techstream to the DLC3.
    10. Turn the engine switch on (IG).
    11. Wait 16 seconds or more.
    12. Turn the Techstream ON.
    13. Enter the following menus: Powertrain/Engine/Trouble Codes.
    14. Read DTCs.

      Result

      Result Proceed to
      No output A
      P060E B

    B → See step   3 

    A → See step   2 

  2. CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS 
  3. REPLACE ECM. Refer to  COMPONENTS 
Chapter Navigation
Return to Chapter: DTC P060E: Internal Control Module Throttle Position Performance
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.