2011 Lexus ES 350FACTORY OEM SERVICE PROCEDURE

EFI Relay: Inspection: Inspection

  1. INSPECT EFI RELAY 
    1. Using an ohmmeter, measure the resistance according to the value(s) in the table below.
      Fig 1: Identifying EFI Relay Terminals
      GTY134142Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard resistance

      Tester connection Specified Condition
      1E-7 - 1E-12 10 kΩ or higher
      1E-7 - 1E-12 Below 1 Ω (Battery voltage applied between terminals 1E-9 and 1E-10)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.