Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Problem Symptoms Table
HINT:
Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom | Suspected Area | See |
|---|---|---|
| Power source mode does not change | AM2 fuse | Refer to Power Source Mode does not Change |
| P-J/B fuse | Refer to Power Source Mode does not Change | |
| P IG2 fuse | Refer to Power Source Mode does not Change | |
| Ignition relay No. 2 (IG2) | Refer to ON-VEHICLE INSPECTION | |
| Power switch | Refer to INSPECTION | |
| Main body ECU | Refer to TERMINALS OF ECU | |
| Room oscillator does not recognize key | Refer to Room Oscillator does not Recognize Key | |
| Harness or connector | Refer to Power Source Mode does not Change | |
| Power switch indicator circuit | Power switch | Refer to INSPECTION |
| Main body ECU | Refer to TERMINALS OF ECU | |
| Harness or connector | Refer to Power Switch Indicator Circuit | |
| Power source mode does not change to ON (READY) | STOP fuse | Refer to Power Source Mode does not Change to ON (READY) |
| Stop light switch | Refer to INSPECTION | |
| Transmission floor shift assembly (shift lock control ECU) | Refer to ON-VEHICLE INSPECTION | |
| Steering lock actuator assembly (Steering lock control ECU) | Refer to TERMINALS OF ECU | |
| Hybrid vehicle control ECU | Refer to TERMINALS OF ECU | |
| ID code box | Refer to TERMINALS OF ECU | |
| Certification ECU | Refer to TERMINALS OF ECU | |
| Main body ECU | Refer to TERMINALS OF ECU | |
| Steering lock system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING | |
| Engine immobiliser system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING | |
| Hybrid control system | Refer to HOW TO PROCEED WITH TROUBLESHOOTING | |
| Power source mode does not change | Refer to Power Source Mode does not Change | |
| Steering lock motor drive power circuit | Refer to Steering Lock Motor Drive Power Circuit | |
| Harness or connector | Refer to Power Source Mode does not Change to ON (READY) |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
