Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Brake Control Power Supply: Installation: Installation
While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the doors while the battery is connected.
- INSTALL NO. 1 BRAKE CONTROL POWER SUPPLY BRACKET
- Install the 2 brackets with the 4 bolts.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
- Install the 2 brackets with the 4 bolts.
- INSTALL BRAKE CONTROL POWER SUPPLY ASSEMBLY
- Connect the connector to the brake control power supply.
- Install the brake control power supply with the 3 nuts.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
- INSTALL BRAKE CONTROL POWER SUPPLY COVER
- If the brake control power supply is replaced, install a new cover as follows:
- Peel off the peeling paper of the double-sided tape.
- Place the cover so that the 4 corner lines on the cover align with the corners of the brake control power supply, and so that the cover arrow is above the connector.
- If the brake control power supply is replaced, install a new cover as follows:
- INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH . Refer to INSTALLATION - Step 5
- INSTALL DECK TRIM SIDE BOARD LH . Refer to INSTALLATION - Step 11
- INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY . Refer to INSTALLATION - Step 15
- INSTALL REAR FLOOR FINISH PLATE . Refer to INSTALLATION - Step 6
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
- INSTALL COWL TOP VENTILATOR LOUVER RH . Refer to INSTALLATION - Step 16
- CHECK AND CLEAR DTC
- Check and clear the DTCs. Refer to DTC CHECK / CLEAR .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
