2010 Lexus IS FFACTORY OEM SERVICE PROCEDURE

Valve Body Assembly: Installation: Installation

  1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY 
    1. Install the spring and check ball body.
      Fig 1: Identifying Check Ball Body And Spring
      GTY102905Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Align the groove of the manual valve with the lever pin.
      Fig 2: Aligning Groove Of Manual Valve With Lever Pin
      GTY128353Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the 17 bolts.
      Fig 3: Locating Transmission Case Bolt Location
      GTY103840Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf) 

      HINT: 

      Each bolt length is indicated below.

      Bolt length

      21 mm (0.827 in.) for bolt A

      31 mm (1.22 in.) for bolt B

      64 mm (2.52 in.) for bolt C

    4. Install the detent spring and detent spring cover with the bolt.
      NOTE:

      Make sure to install the detent spring so that its roller is perpendicularly aligned to the center of the manual valve lever.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.