NOTE:

If any parts are replaced, perform the following as necessary referring to the table below.

Replaced Part		Reset Memory*1	Set Transmission Compensation Code	Learning by Driving (Road Test)
Automatic transmission assembly		-*2	Perform*3	Perform
Valve body assembly Shift solenoid valve SL1, 2, 3, 4 and 5		-	-	Perform
TCM (If possible, read the transmission compensation code from the previous TCM)	Possible	-	Perform*4	Perform
	Impossible	-	Perform*5	Perform
Engine assembly ECM		Perform	-	Perform

HINT:

*1: Reset Memory cannot be completed by only disconnecting and reconnecting the cable to the negative (-) battery terminal.
*2: When "Set Transmission Compensation Code" is performed, "Reset Memory" is automatically completed.
*3: Set the compensation code for the new automatic transmission.
*4: Read the compensation code from the previous TCM, then transfer it to the new TCM.
*5: Set the transmission compensation code of the current automatic transmission.
Registration of the transmission compensation code. Refer to REGISTRATION .
Learning by driving (Road Test). Refer to INITIALIZATION .
Reset Memory. Refer to INITIALIZATION .

NOTE:

Reset Memory cannot be completed by only disconnecting and reconnecting the cable to the negative (-) battery terminal.

Chapter Navigation

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Automatic Transmission System: Precaution: Precaution