Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Lexus IS 350CFACTORY OEM SERVICE PROCEDURE
Service Data
| VSC OFF switch | Resistance 3 (+) - 4 (E) | Switch is pushed in | Below 1 Ξ© |
| Switch is not pushed in | 10 kΞ© or higher | ||
| Brake pedal load sensing switch | Resistance 2 (FSW+) - 1 (GND) | Brake pedal load sensing switch OFF (Brake pedal depressed) | 950 to 1050 Ξ© |
| Brake pedal load sensing switch ON (Brake pedal released) | 203 to 223 Ξ© |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
