2010 Lexus ES 350FACTORY OEM SERVICE PROCEDURE

Transmission Control Cable Assembly: Installation: Installation

  1. INSTALL NO. 2 SHIFT CABLE GROMMET RETAINER 
    1. Pass the control cable from the cabin to the engine compartment.
    2. Install the No. 2 shift cable grommet retainer with the 2 bolts.
      Fig 1: Identifying No. 2 Shift Cable Grommet Retainer And Bolts
      GTY112398Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

  2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Move the shift lever to N.
    2. Install the transmission control cable assembly as shown in the illustration.
      Fig 2: Identifying Transmission Control Cable Assembly And Floor Shift Cable Claws
      GTY111377Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      • Install the floor shift cable with the uneven surface facing up.
      • Securely engage the claws of the floor shift cable.
    3. Connect the control cable to the bracket with a new clip.
      Fig 3: Identifying Transmission Cable Bracket And Clip
      GTY112400Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Install the control cable to the control shaft lever with the nut.
      Fig 4: Identifying Transmission Control Cable And Nut
      GTY112399Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf) 

    5. Push in the lock piece of the transmission control cable.
      Fig 5: Identifying Lock Piece Of Transmission Control Cable
      GTY111927Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.