Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Lexus SC 430FACTORY OEM SERVICE PROCEDURE
Problem Symptoms Table
WARNING: This page is about a different car, the 2011 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
Proceed to the troubleshooting for each circuit in the table below.
OCCUPANT CLASSIFICATION SYSTEM (FROM 12/2010)
| Symptom | Suspected Area | See |
|---|---|---|
| The front passenger seat condition differs from the indication by the passenger airbag ON/OFF indicator (DTC is not output). | Trouble in Passenger Airbag ON/OFF Indicator | Refer to Trouble in Passenger Airbag ON/OFF Indicator |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.