2009 Lexus SC 430FACTORY OEM SERVICE PROCEDURE

Charging (Service Information): Generator: Replacement: Replacement

  1. REPLACE FRONT BEARING 
      Fig 1: Locating Screws And Retainer Plate
      GTY145107Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the 4 screws and bearing retainer.
    2. Fig 2: Pressing Bearing
      GTY123405Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Using SST and a press, press out the bearing.
      • SST: 09223-00010 
    4. Fig 3: Pressing New Bearing
      GTY145103Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Using SST and a press, press in a new bearing.
      • SST: 09950-60010 
    6. Install the bearing retainer with the 4 screws.

      Torque: 2.3 N*m ( 24 kgf*cm, 20 in.*lbf) 

  2. REPLACE REAR BEARING 
      Fig 4: Removing Rear Bearing
      GTY145102Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.