Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Lexus LS 600hLFACTORY OEM SERVICE PROCEDURE
Display Check Mode
WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
- This mode checks the color display on the display and navigation assembly
- Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be exactly the same as on the actual vehicle
- ENTER DIAGNOSTIC MODE (See DTC CHECK / CLEAR )
- DISPLAY CHECK
- Select "Display Check" from the "Diagnosis Menu" screen.
- COLOR BAR CHECK
- Select "Color Bar Check" from the "Display Check" screen
- Select a color bar from the "Color Bar Check Mode" screen.
- Check the display color.
HINT:
- The entire screen turns to the color or stripe selected.
- Touch the display to return to the "Color Bar Check Mode" screen.
- TOUCH SWITCH CHECK
- Select "Touch Switch Check" from the "Display Check" screen.
- Touch the display anywhere in the open area to perform the check when the "Touch Switch Check" screen is displayed.
HINT:
A "+" mark is displayed on the display is touched.
- PANEL SWITCH CHECK
- Select "Panel Switch Check" from the "Display Check" screen.
- Operate each switch and check that the switch name and condition are correctly displayed.DISPLAY REFERENCE CHART
Display Contents Push switch name/* - Name of the pressed switch is displayed
- If more than one switch is pressed, "MULTIPLE" is displayed
- VEHICLE SIGNAL CHECK
- Select "Vehicle Signal Check" from the "Display Check" screen.
- When the "Vehicle Signal Check Mode" screen is displayed, check all the vehicle signal conditions.
HINT:
- Only conditions having inputs are displayed.
- This screen is updated once per second when input signals to the vehicle are changed.
- For details of this function, refer to DIAGNOSIS DISPLAY DETAILED DESCRIPTION .
- CAN CHECK
- Select "CAN Check" from the "Display Check" screen.
- Check the CAN connection check result.
HINT:
- This function operates only for the systems connected to the CAN system.
- For details of this function, refer to DIAGNOSIS DISPLAY DETAILED DESCRIPTION .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
