2009 Lexus LS 600hLFACTORY OEM SERVICE PROCEDURE

Display And Navigation Assembly: Installation

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS )

  1. INSTALL NO. 2 RADIO BRACKET 
    1. Install the bracket with the 2 bolts.
      Fig 1: Locating No. 2 Radio Bracket Bolts
      G04945698Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL NO. 1 RADIO BRACKET 
    1. Install the bracket with the 2 bolts.
  3. INSTALL DISPLAY AND NAVIGATION ASSEMBLY WITH BRACKET 
    1. Connect the connectors.
      Fig 2: Locating No. 1 Radio Bracket Bolts
      G04945699Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Insert the display and attach the 6 clips on its backside.

      HINT:

      Evenly push the right and left sides of the display into the instrument panel.

      Fig 3: Pushing Right And Left Sides Of Display Into Instrument Panel
      G05784392Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the display with the 2 bolts
      Fig 4: Locating Display Bolts
      G04953990Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET  (See INSTALLATION )
  5. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY  (See INSTALLATION )
  6. INSTALL REAR UPPER CONSOLE PANEL  (See INSTALLATION )
  7. INSTALL NO. 3 BOX PANEL  (See INSTALLATION )
  8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY  (See INSTALLATION )
  9. INSTALL INSTRUMENT PANEL FINISH PANEL END RH  (See INSTALLATION )
  10. INSTALL INSTRUMENT PANEL FINISH PANEL END LH  (See INSTALLATION )
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
  12. INSTALL BATTERY SERVICE HOLE COVER LH  (See INSTALLATION )
  13. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY  (See INSTALLATION )
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.