Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Procedure
HINT:
If the navigation type is NAVIGATION SYSTEM (for HDD), "multi-display" refers to the "display and navigation assembly"
- CHECK TOUCH PANEL
- Check for foreign matter on the display
OK: The display is clean.
NG: CLEAN DISPLAY AND RECHECK TOUCH PANEL
OK: Go to next step
- Check for foreign matter on the display
- CHECK TOUCH SWITCH (DISPLAY CHECK MODE)
- Enter the "Display Check" mode (Touch Switch Check) (see DISPLAY CHECK MODE ).
- Touch the display in the area where the switch malfunction occurs
OK: A "+" mark appears at the touched position.
Result
RESULT CHARTResult Proceed to OK A NG (w/ Navigation System [for HDD]) B NG (w/ Navigation System [for DVD]) C NG (w/o Navigation System) D
B: REPLACE DISPLAY AND NAVIGATION ASSEMBLY (see REMOVAL )
C: REPLACE MULTI-DISPLAY (see REMOVAL )
D: REPLACE MULTI-DISPLAY (See REMOVAL )
A: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (See PROBLEM SYMPTOMS TABLE )
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
