2009 Lexus LS 600hLFACTORY OEM SERVICE PROCEDURE

Diagnostic Trouble Code Chart

WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

  • If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to table below.
    Fig 1: Screen Display - OK
    G05783395Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  • If the navigation type is NAVIGATION SYSTEM (for HDD), "multi-display" refers to the "display and navigation assembly".

    Audio and visual system 

    AUDIO AND VISUAL SYSTEM - DIAGNOSTIC TROUBLE CODE (DTC) CHART

    DTC Code Detection Item Trouble area
    01-21  ROM Error Multi-display
    01-22  RAM Error Multi-display
    01-D5  Absence of Registration Unit
    • Power source circuit of component shown by sub-code
    • AVC-LAN circuit between multi-display and component shown by sub-code
    • Component shown by sub-code
    01-D6  No Master
    • Multi-display power source circuit
    • Power source circuit of the component which has stored this code
    • AVC-LAN circuit between the multi-display and the component which has stored this code
    • Component which has stored this code
    • Multi-display
    01-D7  Connection Check Error
    • Multi-display power source circuit
    • Power source circuit of the component which has stored this code
    • AVC-LAN circuit between the multi-display and the component which has stored this code
    • Component which has stored this code
    • Multi-display
    01-D8  No Response for Connection Check
    • Power source circuit of component shown by sub-code
    • AVC-LAN circuit between multi-display and component shown by sub-code
    • Component shown by sub-code
    01-D9  Last Mode Error
    • Power source circuit of component shown by sub-code
    • AVC-LAN circuit between multi-display and component shown by sub-code
    • Component shown by sub-code
    01-DA  No Response Against ON / OFF Command
    • Power source circuit of component shown by sub-code
    • AVC-LAN circuit between multi-display and component shown by sub-code
    • Component shown by sub-code
    01-DB  Mode Status Error
    • Power source circuit of component shown by sub-code
    • AVC-LAN circuit between multi-display and component shown by sub-code
    • Component shown by sub-code
    01-DC  Transmission Error If same sub-code is recorded in other components, check harness of power supply and communication system of all components shown by code
    01-DD  Master Reset
    • Multi-display power source circuit
    • AVC-LAN circuit between multi-display and component which has stored this code
    • Multi-display
    • Component which has stored this code
    01-DE  Slave Reset
    • Power source circuit of component shown by sub-code
    • AVC-LAN circuit between multi-display and component shown by sub-code
    • Component shown by sub-code
    01-DF  Master Error
    • Multi-display power source circuit
    • AVC-LAN circuit between multi-display and component which has stored this code
    • AVC-LAN circuit between multi-display and radio receiver
    • Multi-display
    • Component which has stored this code
    01-E0  Registration Complete Indication Error -
    01-E1  Voice Processing Device ON Error
    • Multi-display power source circuit
    • AVC-LAN circuit between multi-display and component which has stored this code
    • Multi-display
    • Component which has stored this code
    01-E2  ON / OFF Indication Parameter Error Multi-display
    01-E3  Registration Demand Transmission -
    01-E4  Multiple Frame Incomplete -
    21-10  Panel Switch Error Multi-display
    21-11  Touch Switch Error Multi-display
    23-10  Panel Switch Error Multi-display
    23-11  Touch Switch Error Multi-display
    24-10  Panel Switch Error Multi-display
    24-11  Touch Switch Error Multi-display
    25-10  Panel Switch Error Multi-display
    25-11  Touch Switch Error Multi-display
    34-10  Error in Picture Circuit Multi-display
    34-11  No Current in Back-light Multi-display
    34-12  Excess Current in Back-light Multi-display
    45-10  DVD Changer Mechanical Error Radio receiver
    45-11  DVD Insertion and Ejection Error Radio receiver
    45-12  DVD Reading Abnormal Radio receiver
    45-41  Wrong Disc
    • Disc
    • Radio receiver
    45-42  Disc cannot be Read
    • Disc
    • Radio receiver
    45-43  DVD-ROM Abnormal
    • Disc
    • Radio receiver
    45-44  DVD Malfunction Radio receiver
    45-45  Eject Error Radio receiver
    45-46  Scratched/Reversed Disc
    • Disc
    • Radio receiver
    45-47  High Temperature Radio receiver
    45-48  Excess Current Radio receiver
    45-50  Tray Insertion / Ejection Error Radio receiver
    45-51  Elevator Error Radio receiver
    45-52  Clamp Error Radio receiver
    45-78  DSP Error Radio receiver
    45-7D  Disc cannot be Played
    • Disc
    • Radio receiver
    45-7E  No Playable Files
    • Disc
    • Radio receiver
    45-7F  Copyright Protection Error
    • Disc
    • Radio receiver
    57-47  Bluetooth Module Initialization Failed Multi-display
    5C-40  Camera Picture Error
    • Harness and connector
    • Television camera
    • Multi-display
    60-10  AM Tuner PLL does not Lock Radio receiver
    60-11  FM Tuner PLL does not Lock Radio receiver
    60-42  Tuner Power Source Error Radio receiver
    60-43  AM Tuner Error Radio receiver
    60-44  FM Tuner Error Radio receiver
    60-50  Malfunction in Internal IC Radio receiver
    63-10  CD Changer Mechanical Error Radio receiver
    63-11  CD Insertion and Ejection Error Radio receiver
    63-12  CD Reading Abnormal Radio receiver
    63-41  Wrong Disc
    • CD
    • Radio receiver
    63-42  Disc cannot be Read
    • CD
    • Radio receiver
    63-43  CD-ROM Abnormal
    • CD
    • Radio receiver
    63-44  CD Abnormal Radio receiver
    63-45  Eject Error Radio receiver
    63-46  Scratched / Reversed Disc
    • CD
    • Radio receiver
    63-47  High Temperature Radio receiver
    63-48  Excess Current Radio receiver
    63-50  Tray Insertion / Ejection Error Radio receiver
    63-51  Elevator Error Radio receiver
    63-52  Clamp Error Radio receiver
    63-78  DSP Error Radio receiver
    63-7D  Disc cannot be Played
    • CD
    • Radio receiver
    63-7E  No Playable Files
    • CD
    • Radio receiver
    63-7F  Copyright Protection Error
    • CD
    • Radio receiver
    74-40  Short in Speaker Circuit
    • Harness and connector
    • Speaker
    • Stereo component amplifier
    D2-42  Disc cannot be Read
    • Disc
    • Radio receiver
    D2-44  Disc Malfunction Radio receiver
    D2-45  Eject Malfunction Radio receiver
    D2-46  Disc is Scratched, Dirty or Reversed
    • Disc
    • Radio receiver
    D2-52  Clamp Malfunction Radio receiver
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.