Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Lexus LS 600hLFACTORY OEM SERVICE PROCEDURE
Torque Specifications
WARNING: This page is about a different car, the 2008 Lexus LS 600hL. However, it is still accessible from the selected car via links, so may be relevant.
LIGHTING - TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Front height control sensor x Body | 80 | 82 | 71 in lbf |
| Front height control sensor x Lower arm | 54 | 55 | 48 in lbf |
| Rear height control sensor x Rear suspension member | 80 | 82 | 71 in lbf |
| Rear height control sensor x Lower arm | 54 | 55 | 48 in lbf |
| Stop light switch x Brake pedal support | 17 | 170 | 12 |
| Luggage door closer x Body | 55 | 56 | 49 in lbf |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.